(this part is required for Android.) If you don’t click yes or clicked out of that notification too fast, you can go into your wifi settings, click and hold the network, and then confirm it that way.
#Opensprinkler pi setup android
If you have an Android phone, you will receive a notification that says “wifi has no internet connection”, which is normal. This creates an adhoc wireless network called something like “OS_Last6ofMACaddress).Ĭonnect your phone to this network.
Once powered up, OpenSprinkler starts in AP mode. Chances are the red and black cables connecting to the orange block aren’t seated correctly. If it doesn’t boot up right away – don’t fret. There are no physical on/off buttons, but the LCD panel should start displaying a text indicating that’s it booting up. Once all the cables are plugged, plug your AC power brick into the wall. If you have ground (GND) or rain sensors (I don’t), then plug those into OpenSprinkler as well. Do this one last, as you probably don’t want to provide power to OpenSprinkler until everything is setup correctly.
The power cable will be inserted into the orange block it doesn’t matter which side they go into. The black power cable has a red and a black wire. The white COM wire goes into the COM port. Once you have your OpenSprinkler setup, you will assign your P/MV to the “Master” section. Plug this into an available zone (either 7 or 8). The black P/MV cable is your pump/master valve. The red zone cables should be inserted into the corresponding zones (Zone 1 on the old system goes into #1 on OpenSprinkler). Insert each wire and tighten them down with a small screwdriver. Just in case you didn’t know, the orange and green wiring blocks can be removed to insert the cables in easier. Then, you will insert those cables into the corresponding ports on the OpenSprinkler unit. Your setup might not have a P/MV wire, but if it does – you’ll need to plug that into an available Zone port on OpenSprinkler. In short, the only cables you really need to unplug from the old system into the new are: I’ve never opened up my sprinkler before, so this was all brand new for me.
#Opensprinkler pi setup how to
However, one thing that was lacking was how to physically install the various cables and zones into the unit. If you ever move houses and plan on keeping your OpenSprinkler, then you can quickly plug the wires back in correctly to the old system.
I recommend taking the time to label every cable and takes pictures. I purchased both the OpenSprinkler unit and 24VAC adapter from here: Įverything you need to know about installing OpenSprinkler can be found in the getting started guide. If you’d like to go the DIY route, you can follow one of their github guides to install it on a raspberry pi. If you purchase the pre-assembled kit, nothing else is needed and no soldering is required. Total cost was $172.95 for both after shipping. I just purchased the pre-assembled OpenSprinkler with a 24v AC adapter. I currently have a 6-zone Hunter Pro-C, so I didn’t need to purchase one. Depending on how many sprinkler zones you have will determine whether you need to purchase a Zone Expander. In this guide, I will show you how to install OpenSprinkler into your existing sprinkler system in 2021.įirst, read over their getting started guide. If you’d like to play around with a live demo, you can do that here: OpenSprinkler is web-based sprinkler controller for your lawn, garden, or plants. After doing some research, I stumbled across an open source project called OpenSprinkler. One of the most recent smarthome projects I’ve worked on was making my sprinkler system “smart”.
0 kommentar(er)
